Flow And/Or Pressure Units Of Measure; Pump Selection (If Multiple Pumps); Refill; Menu 1 Program Selections - Teledyne SyriXus 65x Installation And Operation Manual

Figure 3-1 Menu 1 program selections
3.4.1 Flow and/or
Pressure Units of
Measure
Figure 3-2 Units menu
3.4.2 Pump Selection
(if Multiple Pumps)

3.4.3 Refill

EAR99 Technology Subject to Restrictions Contained on the Cover Page
SyriXus Series Pumps Installation and Operation Guide
1. UNITS
2. SELECT PUMP
3. REFILL
MORE
Displayed units are user-selectable by selecting menu 1 item 1.
PRESSURE UNITS=___________FLOW UNITS=__________
1. ATM
2. BAR
A
• Use numbers 1-4 to select the pressure units (ATM, BAR, PSI,
kPa). The units selected will be displayed on the first line after
PRESSURE UNITS=.
• Use numbers 5-8 (mL/MIN, mL/HR, µL/MIN, µL/HR) to set the
flow rate units. The selected units will be displayed on the first
line after FLOW UNITS=.
If multiple pumps are connected to a single controller, the
option selects the pump (A, B, C, or D) whose current state and
PUMP
settings appear on the display.
The letter of the current pump will appear in lower-case in the upper
left corner of the run screen.
When multiple pumps are connected, the UNITS selected for one
pump will apply to all of the pumps.
The refill option allows you to set the refill rate or set the pump to
automatically refill when a certain volume is reached.
This feature may be less desirable when pumping liquefied gases or
volatile fluids. During refill, the cylinder must be able to aspirate the
refill reagent from the solvent reservoir, which will be less effective if
the cylinder is not empty and the fluid is highly compressible or
changes phases.
Press > (3). The auto refill menu will appear.
REFILL
MENU
Section 3 Basic Programming and Operation
4. POWER FAILURE [STOP]
5. SYSTEM RESET
6. DISPLAY CONTRAST
PSI
3. 5.
mL/MIN
4. kPA 6. mL/HR
C
B
NOTE
NOTE
RETURN
7. µL/MIN
µL/HR
8.
PREVIOUS
D
SELECT
3-5