Continuous Flow System; Modifier Addition Kit Installation (Continuous Flow) - Teledyne SyriXus 65x Installation And Operation Manual

6.1.3 Continuous Flow
System
Figure 6-2 Modifier addition kit installation (continuous flow)
EAR99 Technology Subject to Restrictions Contained on the Cover Page
SyriXus Series Pumps Installation and Operation Guide
The pump with the primary working fluid needs to be connected to
the PUMP A electrical connector on the controller, and the pump
being used for the modifier needs to be connected to the PUMP B
electrical connector on the controller.
When working with a modifier that boils at room temperature, a
pressurized reservoir for the modifier fluid may be useful to reduce
or prevent vaporization.
The modifier pump is a single pump. When modifier pump cylinder
is empty, the system stops. The cylinder must be manually refilled
before the system can run again.
Section 6 Modifier Addition
NOTE
NOTE
NOTE
6-3