Section 2 Fluid System Connections And Accessories; Introduction; Fluid System Connections; Standard Port Information - Teledyne SyriXus 65x Installation And Operation Manual

SyriXus Series Pumps Installation and Operation Guide

Section 2 Fluid System Connections and Accessories

2.1 Introduction

2.2 Fluid System
Connections
2.2.1 Ports
EAR99 Technology Subject to Restrictions Contained on the Cover Page
This section discusses general fluid system connections, and the
installation of fluid connection accessories, temperature/pressure
control accessories, and optional kits and attachments.
RISK OF INJURY. THIS EQUIPMENT PRODUCES
HAZARDOUS PRESSURES. USE APPROPRIATE
TUBING AND CONNECTIONS AS INSTRUCTED.
When operating at flow rates at or below 500 µL/min, it is strongly
suggested that an insulating cover or temperature control jacket be
installed. Refer To Section 2.4.1 "Temperature Control Jacket".
All SyriXus series syringe pump models connect similarly, but with
varying port sizes. Take care to follow procedures provided to ensure
safety and proper operation.
There are two ports in the pump standard cylinder cap. Either port
can serve as the inlet or outlet. As shown in Figure 2-1, you may plug
one port and use a single port as both the inlet and outlet.
Table 2-1 Standard Port Information
1000x - 1/4" NPT
260x - 1/8" Valco
500xv - 3/8" NPT
DANGER
NOTE
500x - 1/8" NPT
65x- 1/4" F250C
2-1