Error Messages - Teledyne SyriXus 65x Installation And Operation Manual

8.8.5 Error Messages

Error
PROBLEM=LOCAL MODE
PROBLEM=INVALID COMMAND
PROBLEM=INVALID OPERAND
PROBLEM=PUMP RUNNING
PROBLEM=OVERPRESSURE
PROBLEM=UNDERPRESSURE
PROBLEM=CYLINDER EMPTY
PROBLEM=CYLINDER FULL
PROBLEM=NO PUMP
PROBLEM=WRONG PUMP
MODE
EAR99 Technology Subject to Restrictions Contained on the Cover Page
SyriXus Series Pumps Installation and Operation Guide
If an error occurs in a message, one of the following responses will be
sent. The format of an error message is 'PROBLEM=_____.' Refer to
Table 8-4 "Error Messages".
Table 8-4 Error Messages
The pump was sent a command before being placed in remote mode. Refer to
Section 8.8 "Serial Commands for the SyriXus Series Pumps".
The command sent was not recognized by the pump.
The operand (character(s) following the = sign) is missing or is incorrect; e.g.,
the number was too large.
The command sent is only valid when the pump is stopped.
Sent in response to a high or low pressure limit condition.
Sent when the pump cylinder is empty.
Sent when the pump cylinder is full.
Sent when the pump is not present
Sent when the pump is in the incorrect mode for the command.
Section 8 Serial Interface
Description
8-35