Usb Interface; Cabling For Serial Control; Usb Interface Pin Connections - Teledyne SyriXus 65x Installation And Operation Manual

8.3 USB Interface

8.4 Cabling for Serial
Control
EAR99 Technology Subject to Restrictions Contained on the Cover Page
SyriXus Series Pumps Installation and Operation Guide
The Teledyne ISCO SyriXus series syringe pump controller may
include an optional USB interface. The USB connections are located
on the pump controller rear panel labeled USB/Ethernet. The con-
nector pin usage is outlined in Table 8-2 "USB Interface Pin Connec-
tions". Use optional cable (P/N 60-1244-487) to connect the USB to the
25 pin connector labeled USB/Ethernet. The drivers for the USB can
be downloaded from http://www.isco.com/support/updates.asp.
Connecting devices to energized circuits may cause personal
injury or property damage. Power must be removed from the
pump before connecting external devices.
The cable (P/N 60-1244-487) will only work when attached to the
optional USB/Ethernet connector on the back of the controller. Con-
necting this cable to any other connector on either the pump or con-
troller will not work.
Table 8-2 USB Interface Pin Connections
Pin No.
7
11
12
The serial connection feature allows the SyriXus series pumps to be
controlled remotely from a personal computer through a common
serial connector (RS-232-C). Almost all the pump commands available
through the controller front panel can be handled by a user defined
computer program to remotely control the pumps. Refer to Section 8.8
"Serial Commands for the SyriXus Series Pumps" for command
syntax.
The cabling scheme for your system will depend on the number of
instruments you need to control. When using serial control, the per-
sonal computer or laptop is always connected from the serial port to
the serial port(s) of the SyriXus series controller(s) it is controlling.
Each controller is connected to its pumps in the normal fashion, i.e.
the pump control cables are attached to the pump 'A', 'B', 'C', and 'D'
connectors on the rear panel of the pump controller. The cable you
select to connect to your network will depend on the type of serial port
your computer has and the number of controllers you wish to connect.
Network communications are initiated by your computer.
Section 8 Serial Interface
WARNING
NOTE
Name
GND
Data -
Data +
NOTE
8-3