Rates, Units, And Limits; Programming Screens; Run Screens - Teledyne SyriXus 65x Installation And Operation Manual

3.2.2 Rates, Units, and
Limits
3.2.3 Programming
Screens

3.2.4 Run Screens

EAR99 Technology Subject to Restrictions Contained on the Cover Page
SyriXus Series Pumps Installation and Operation Guide
• To allow pump operation to be tailored to your application, both
the pressure and flow rate units may be set by the user. Refer to
Section 3.4.1 "Flow and/or Pressure Units of Measure".
• The pump also allows for user programmed refill, as well as
pumping rates. Refer to Section 3.4.3 "Refill".
• The system protection limits may also be set by the user, refer to
Section 3.8.7 "LIMITS".
The programming screens are divided into separate menus. These
menus are accessed when different features are being programmed.
For complete information about programming menus, refer to Section
3.3 "Main Menus" through Section 3.7 "Menu Four".
The run screen is shown once a program has been loaded and the
pump is running.
The run screen, which is determined by your program selections, dis-
plays current information about pump operation. The following sec-
tions explain the display line-by-line.
• Line One - Regardless of mode, the first line of the run screen is
always the same.
Active
Pump
Actual Pressure
PGa .000 mL/MIN
Current Mode
• Line Two - The second line varies slightly depending on the
operating mode. A file or step will only be displayed when
operating in the Gradient Mode.
STOPPED FILE/STEP
Status
• Line Three - Line three varies depending on the mode; the rate
and units are set by the user, so these will vary depending on
your programming requirements. The ending time will always be
displayed on this line.
Section 3 Basic Programming and Operation
Volume Remaining
PSI
Actual Flow Rate
Elapsed Time
Step of program running or
loaded file number
XXX.XX ml
000:00:00
3-3