Operating Modes - Teledyne SyriXus 65x Installation And Operation Manual

SyriXus Series Pumps Installation and Operation Guide
Section 3 Basic Programming and Operation

3.10 Operating Modes

EAR99 Technology Subject to Restrictions Contained on the Cover Page
3-18
The pump has three Deliver Modes and one Refill Mode.
When using a single controller to operate multiple pumps inde-
pendently, you need to select the appropriate pump run screen
before selecting a mode. To select the appropriate pump, press
SELECT PUMP (D) and an intermediate screen will be shown.
Press the softkey for the appropriate pump, the run screen for that
pump will appear.
• Constant Flow
Refer to Section 3.10.1 "Constant Flow". This mode is used when
the flow rate must remain constant during the pumping
operation.
• Constant Pressure
Refer to Section 3.10.2 "Constant Pressure". The Constant
Pressure Mode is used when the application of fixed pressure
throughout the pumping operation is required. The pump will
maintain the desired pressure by positive or negative
displacement of the piston.
• Programmed Gradient
Refer to Section 4 "Gradient Pumping for Pressure, Flow, and
Concentration Modes". In the programmed Gradient Mode, the
pump can provide the following types of gradient:
• Two-pump concentration gradient on pumps A and B
• Single-pump linear pressure gradients on pump A
• Single-pump flow programs on pump A
One pump must be connected to "Pump A" and powered ON for the
controller to work.
• Dispense
For applications requiring delivery of a specific volume. Refer to
Section 3.10.3 "Dispense Mode".
• Refill
Refer to Section 3.4.3 "Refill". You can set the refill rate and
change it when in Refill Mode.
NOTE
NOTE