Pump Controller Rear Panel Connectors - Teledyne D series Installation And Operation Manual

D Series Syringe Pumps
Section 1 Introduction
9
8
7
6
Figure 1-6 Pump controller rear panel connectors
Table 1-12 Pump Controller Rear Panel Connectors
Item No. on Connector
Figure 1-6
1 PUMP D
2 PUMP C
3 PUMP B
4 PUMP A
5 ACCESSORY
6 RS-232/RS-485
7 USB/ETHERNET
1-16
10
5
Description
This connector is only used during multiple pump operation. The control
cable from the rear panel of the fourth pump is attached to this connector.
This connector is only used during multiple pump operation. The control
cable from the rear panel of the third pump is attached to this connector.
This connector is only used during multiple pump operation. The control
cable from the rear panel of the second pump is attached to this connector.
This plug connects the control cable from the pump rear panel. This connec-
tion should be secured with the thumbscrews.
IMPORTANT: The pump A connector is the only input power connector on
the rear panel of the controller. During single pump operation, the pump must
be attached to this connector to supply power to the controller.
WARNING
Do not connect or disconnect the control cable when the pump is con-
nected to the mains voltage.
These terminals allow connection of input and output signals
(such as analog controls and external RUN/STOP).
This serial port connector may be used with an RS-232 or RS-485 cable to
place the pump under remote control. Refer to Section 8 for RS-232 and
Section 7 for RS-485 pin connections.
a
Optional circuit provides USB and Ethernet functionality. Refer to Section 8
for USB pin connections and Section 7 for Ethernet pin connections
11
1
2
3
4