Error Messages - Teledyne D series Installation And Operation Manual

D Series Syringe Pumps
Section 8 Serial Interface

8.8.5 Error Messages

8-34
If an error occurs in a message, one of the following responses
w i l l b e s e n t . T h e f o r m a t o f a n e r r o r m e s s a g e i s
"PROBLEM=_____." Refer to Table 8-7.
Table 8-7 Error Messages
Error
PROBLEM=LOCAL MODE
PROBLEM=INVALID COMMAND
PROBLEM=INVALID OPERAND
PROBLEM=PUMP RUNNING
PROBLEM=OVERPRESSURE
PROBLEM=UNDERPRESSURE
PROBLEM=CYLINDER EMPTY
PROBLEM=CYLINDER FULL
PROBLEM=NO PUMP
PROBLEM=WRONG PUMP MODE Sent when the pump is in the incor-
Description
The pump was sent a command
before being placed in remote mode.
See Section 8.8.
The command sent was not recog-
nized by the pump.
The operand (character(s) following
the = sign) is missing or is incorrect;
e.g., the number was too large.
The command sent is only valid when
the pump is stopped.
Sent in response to a high or low
pressure limit condition.
Sent when the pump cylinder is
empty.
Sent when the pump cylinder is full.
Sent when the pump is not present
rect mode for the command.