Pilz PMCprimo MC Operating Manual page 58

Operation
"Startup" operating status has been run without error. The system changes to "STOP"
status if no user program was loaded in "Startup" status.
1
The system changes to "Fatal Error" status if an error occurred in "Startup" status.
2
The system changes to "Startup" status if the "Boot Menu" in the terminal program is exited
using the command O or ESC.
3
The system performs a hardware reset after
Running the command RS1 in the terminal program (cold start).
}
Holding down the reset button for a long period (> 4 s) (alternative to RS1 command).
}
3
The system performs this status change after
Running the following commands in the terminal program:
}
– RS3 (change to "STOP")
– RS4 (warm reset), stops the user program
– RS5 (cold reset), stops the user program
– RS5 (original reset), deletes the user program
Running commands in the IEC 61131 development environment.
}
Holding down the reset button for a short period (< 4 s) (alternative to RS3 command,
}
change to "STOP").
3
The system changes to "Fatal Error" status if an error occurred in "RUN" status.
Remedy
Delete user program
}
Firmware update
}
4
The system performs a hardware reset after
Running the command RS1 in the terminal program (cold start).
}
Holding down the reset button for a long period (> 4 s) (alternative to RS1 command (cold
}
start)).
4
The system performs this status change after
Running the command RS2 in the terminal program (change to "RUN").
}
Running commands in the IEC 61131 development environment:
}
Operating Manual PMCprimo MC
1003813-EN-03
5
--> Change from "Startup" to "Fatal Error"
1
--> Change from "Boot Menu" to "Startup"
1
--> Change from "RUN" to "Startup"
4
--> Change from "RUN" to "STOP"
5
--> Change from "RUN" to "Fatal Error"
1
--> Change from "STOP" to "Startup"
3
Change from "STOP" to "RUN"
-->
| 58