Waking Up The Scanner From The Power Save Mode - Fujitsu IMAGE SCANNER FI-4860C Operator's Manual

1.2 Waking up the Scanner from the
Power Save Mode
The Power Save Mode keeps the scanner in a low powered state.
If no operation is performed on the scanner for a while (15 minutes to 60 minutes depending on
the timer setup), the scanner automatically switches to the Power Save Mode.
In the Power Save Mode, the operator panel LCD display goes out. The green LED stays lit.
To wake up the scanner from the Power Save Mode, perform one of the following:
- Load documents on the hopper
- Press a button, except Power button, on the operator panel
- Send a command from the PC

1.2 Waking up the Scanner from the Power Save Mode

1
5