Fujitsu IMAGE SCANNER FI-4860C Operator's Manual page 199

5. Setting Double-feed detection (by document length)
1) Press (Next button) or
2) At <Screen5>, by pressing
feed detection by document length can be enabled or disabled.
By checking the document length deviation when partially over wrapped two sheets are
fed. In this screen, you can specify if the length check is done, set the detection
conditions, and select the error processing.
By pressing
By pressing
(1) [No] is blinking:
(2) [Yes] and [1] are blinking:
(3) [Yes] and [2: Stop] are blinking:
If you would like to disable the Double-feed detection, select [No] and press
(Enter button).
HINT
176
7.3 Setup Mode Details
(Previous button) and let the scanner show <Screen5>.
<Screen5>
0 5
!
= N /
o
(Left arrow button) or
(Right arrow button), selection moves from (1) to (3).
(Left arrow button), selection moves from (3) to (1).
The blinking item is the one selected.
L e n g h
t
1 / 2
Y e s
(Right arrow button), Double-
Document length is not checked.
Document length is checked.
However, scanning continues even if Dou-
ble-feed is detected and the error message
is displayed on the LCD.
Document length is checked.
When double-feed is detected, scanning
stops. Then the error is reported to the PC.
h c
C e k
: S t o p