Download Print this page

Fujitsu FI-4860C Installation Procedures

Scsi (650) vrs scanner installation on windows me\2000\xp.
Hide thumbs
   

Advertisement

Fujitsu SCSI (650) VRS
If you are installing the following models by means of the Kofax 650 Adrenaline SCSI
controller with/without a GSA-2 then use this document.
M4097D-VRS
Fi-5650C-VRS
If you do not have a 650 controller and are not going to use VRS then use the SCSI
scanner installation guide. If you are going to use the optional video interface then use
the video scanner installation guide. If you have an 850S/1700S controller and a GSA-1
interface then you must use the SCSI (GSA-1) VRS scanner installation guide.
Hardware requirements.
You will need a PC system that meets both Fujitsu's and Kofax's recommended
specifications, a Kofax 650 Adrenaline controller and six foot (maximum) Wide SCSI 68-
pin cable. For recommended PC system specifications and SCSI controllers please
reference the
Scanner Hardware Reference
System Disk.
Step A: Installing the VRS drivers.
First boot your PC and install the Kofax VRS driver that shipped with the scanner.
Special note: When installing the VRS driver and any other software that contains
Kofax's Image Controls pay close attention to the individual runtimes. It is strongly
recommended that you install the oldest/lower runtime application first.
Step B: Installing the Adrenaline 650 Adrenaline controller
1. Shut down your PC and remove the case cover.
2. Locate a free PCI slot and remove the back plate if necessary.
3. Install the SCSI controller in an open PCI slot. Make sure that the card is
seated completely in the slot and secured in the frame.
Warning! Failure to secure the SCSI controller in the PC can result in damage
to the SCSI card, scanner, and/or your system.
4. Boot your PC without the scanner attached and check for errors. Make sure
that the SCSI controller is listed as a 650 Adrenaline. If no errors proceed to
the next step.
Step C: Unlocking the shipping lock.
If your model scanner does not have a flatbed then proceed to Step D.
Rev052206A
Scanner Installation Procedures
Windows ME\2000\XP
M4099D-VRS
Fi-5750C-VRS
Fi-4860C-VRS
page. You may also need your Operating
Fi-4990C
Page 1 of 3

Advertisement

   Related Manuals for Fujitsu FI-4860C

   Summary of Contents for Fujitsu FI-4860C

  • Page 1

    SCSI (GSA-1) VRS scanner installation guide. Hardware requirements. You will need a PC system that meets both Fujitsu’s and Kofax’s recommended specifications, a Kofax 650 Adrenaline controller and six foot (maximum) Wide SCSI 68- pin cable.

  • Page 2

    Fujitsu SCSI (650) VRS The flatbed model scanners typically include a lock on the flatbed designed to protect the scanner during shipment. Before the scanner can be used the shipping lock must be unlocked. To unlock it do the following: 1.

  • Page 3

    Step F: Installing third party software applications. After you have successfully installed all the Fujitsu software and hardware, then it is time to install any additional third party scanning software that you wish to use. Please follow the software manufacturer’s instructions for installation. Remember when installing any software that contains Kofax’s Image Controls pay close attention to the individual...

This manual also for:

Fi-4220c2 Fi-4340c Fi-4530c Fi-4990c Fi-5120 Fi-5220c... Show all

Comments to this Manuals

Symbols: 0
Latest comments: