Fujitsu fi-4860C2 Cleaning Instructions

BEFORE CLEANING
Remove documents from the stacker.
Pull up the lever on the right front of
the upper transport and raise it.
Cleaning the Pad -
1
Pull the ADF release lever towards you
and lift up the ADF upper sheet guide.
Guide Plate
Cleaning the Pick Roller -
1
While pulling the ADF lever towards you,
lift up the ADF upper sheet guide.
ADF Upper Sheet Guide
ADF
Release
Lever
Parts
Pad
Pick Roller
Brake Roller
Cleaning Kit
Note: Please ensure Cleaner F2 is NOT
used on Rubber Rollers.
Recommended Cleaning Cycle Every 300,000 Sheets
2
Press down on the upper part of the
guide plate with your fingers at the
two positions shown, rotate the plate
towards you and remove it.
Pad Assy
Recommended Cleaning Cycle Every 300,000 Sheets
2
Slide the Pick Roller unit to the left to
disengage the clutch ring from the shaft.
Ring
Shaft
Cleaning Instructions for
fi-4860C2 Scanner
Part Number
For further cleaning
CA04315-G730
instructions please
CA03296-F711
CA04315-F705
SC-CLE-KIT2
Scanner Operators
which can be found on
www.fel.fujitsu.com/scanner
3
Wipe the translucent rubber part of
the pad ASSY using cleaning paper
moistened with cleaner F1.
Pad (Cleaning Area)
Guide
Plate
3
Wipe both Pick Rollers (2 positions)
and the Separation Roller using
cleaning paper moistened with F1
Pick Roller Unit
cleaner.
refer to the
fi-4860C2 Image
Guide
our Website:
Pad
Assy
Ring Ring
Separation
Roller
Pick Roller Unit