Fujitsu IMAGE SCANNER FI-4860C Operator's Manual page 225

22. Setting Interface
1) Press (Next button) or
2) At <Screen22>, press
the type of interface.
HINT
Available interface settings are as follows:
(1)[Auto] is blinking:
(2) [SCSI] is blinking:
(3) [TPS] is blinking:
By pressing
By pressing
(3) Press
Press
screen.
202
7.3 Setup Mode Details
(Previous button) and let LCD display <Screen22>.
<Screen22>
! 2 2
= A
(Left arrow button) or
The blinking item is the one selected.
If an interface board, either from third party or optional, is
installed in TPS, this interface is used. If not, SCSI inter-
face is used.
SCSI interface is used. The interface on TPS is disre-
garded.
TPS interface is used. The SCSI interface is disregarded.
(Left arrow button), selection moves from (3) to (1).
(Right arrow button), selection moves from (1) to (3).
(Enter button) and make the setting valid.
(EXIT button) at the end and the LCD display goes back to [Ready]
I n t e r f
u t o / S C S
(Right arrow button), and select
a c e
I / T S
P