Fujitsu IMAGE SCANNER FI-4860C Operator's Manual page 275

<Checking Consum-
ables>
<Print cartridge not
set>
■ Alarm message (Hardware error)
The following messages are displayed, when an error occurs inside the sccaner. In this
case, please switch on the power supply once again after disconnecting the power
supply.
If the same message is displayed again, please contact to a distributor or an nearest
imaging service and support center for help.
<Optical alarm >
(Front side)
<Optical alarm >
(Back side)
●
AP-12
The following message is displayed, when the Abration counter
value exceeds the setting value to display an consumables
replacement message.
A b r
The following message is displayed, when the Print cartridge is
not set to fi-486PRFR (Imprinter of front-side) or to fi-486PRRE
(Imprinter of rear-side).
P r e
N o
I
P o s
N o
I
The following message is displayed, when an error occurs to the
front side optical unit.
F r o
O p
t
The following message is displayed, when an error occur to the
back side optical unit.
B a c
O p t
a t i o n a
n k C a r t
t
n k
C a r t
n t S i d e
i c a l A l
S i e
k d
i c a l A l
r m
l a
r i d g e
d g e
r i
a r m
a r m