Miscellaneous; Remove The Feet; Remove The Card Cage Assembly - Christie J Series Service Manual

Section 4: Parts and Module Replacement

4.10 Miscellaneous

4.10.1 Remove the Feet

(12 minutes)
1. Remove the top cover. See
2. Use the needle nose pliers to remove the c-clip from each leg.
3. Unscrew the foot from the bottom of the projector to remove.

4.10.2 Remove the Card Cage Assembly

(16 minutes)
1. Remove the top cover. See
2. Remove (3) 3 mm hex screws from the transparent engine duct on top of the engine cover. Remove the
engine duct.
3. Remove (1) 3 mm hex screw from the black card cage duct on the side of the card cage, as shown in red.
Remove the card cage duct.
4. Remove (12) #2 Phillips® screws from the metal lid on the top of the card cage, as shown in yellow.
Remove the lid.
5. Remove (22) harnesses that are connected to the panel driver. Remove the harnesses from the panel driver
harness clips.
NOTICE! Make note of which harnesses are routed through which clips.
6. Remove (2) black #2 Phillips® screws, which secure the front side of the card cage to the keypad.
7. Remove (2) 3 mm hex screws, which secure the card cage to the base.
8. Remove the LVPS AVC harness from the back of the card cage.
9. Pull the card cage towards yourself to release the rear bracket from the fixed guide pins.
10. Lift the card cage assembly out of the unit.
NOTE: The LVPS will still be attached to the rear of the card cage.
4-28
Remove the Top Cover.
Remove the Top Cover.
J Series 1000W and 1200W Service Manual
020-100725-04 Rev. 1 (07-2015)