7. Remove (13) #2 Phillips® screws from the panel driver.
8. Remove (8) 3/16-inch socket head screws from the control ports on the face of the panel driver.
9. Gently lift the panel driver from the area shown to break the connection with the backplane. Remove the
panel driver.
4.9.9 Remove the Image Processing Card
(2 minutes)
1. Loosen (2) #2 Phillips® captive screws on either side of the card.
2. Pull the locking handles back and sideways to release the connection to the backplane.
3. Gently slide the card out of the unit.
4.9.10 Remove the Optional Cards
(2 minutes)
1. Loosen (2) #2 Phillips® captive screws on either side of the card.
2. Pull the loosened screws to release the connection to the backplane.
3. Gently slide the card out of the unit.
J Series 1000W and 1200W Service Manual
020-100725-04 Rev. 1 (07-2015)
Section 4: Parts and Module Replacement
4-27