Status Led; Electronics/Sw - Christie J Series Service Manual

6.2.10 Status LED

NOTE: Status LEDs are located at the rear of the projector (1 to 4 - top to bottom).
Status LEDs
Shutter
Status
Comm
Lamp

6.2.11 Electronics/SW

Image Device
Video Format Re-Sizing
Picture in Picture
Built-in 2D keystone and geometry
correction
Auto-scaling
Auto-de interlacing
Edge blending
Warping
Tiling (max array size)
Blanking and Image positioning
Brightness, contrast, color, and uniformity
Image orientation
Electronics HW access
Number of option cards
Number of processor cards
Number of option slots
Arbitrary Gamma
J Series 1000W and 1200W Service Manual
020-100725-04 Rev. 1 (07-2015)
# LED Colour
1 Green
Yellow
2 Off
Yellow
Green
Flashing red
3 Flashing red
4 Off
Yellow
Green
Flashing red
Flashing yellow
Feature
Shutter is open
Shutter is closed
AC power is off
AC is present but projector is in standby
Power is powered up and operating normally
Error has occurred. Details are displayed on the status display
Error has occurred. Details are displayed on the status display
Lamp off
Lamp time has expired and lamp should be replaced
Lamp is on and operating correctly
Lamp has malfunctioned
Lamp door is open
Supports 3-chip DMD operation
All video formats can be resized to fill screen either horizontally or
vertically while maintaining aspect ratio
Supported
Supported
Supported
Supported
Supported
Supported
3-by-3 Standard Image Processor and 2-by-2 Dual Image Processor
Supported
User setable control
Can display image front/rear screen, normal/inverted (ceiling)
Mounted at the back of the projector
6 user inter-changeable – hot swapable
2 user inter-changeable
4, option cards; 1, processor card
User definable gamma curves
Section 6: Specifications
LED States
Comments
6-5