Table of Contents
Advertisement
Proline Promag 53 PROFIBUS DP/PA
CE mark
C-Tick symbol
Ex approval
Compatibility with foodstuffs
PROFIBUS DP/PA
certification
Pressure device approval
Other standards and
guidelines
Endress+Hauser
10.1.12 Certificates and approvals
The measuring system is in conformity with the statutory requirements of the EC Directives.
Endress+Hauser confirms successful testing of the device by affixing to it the CE mark.
The measuring system complies with the EMC requirements of the "Australian Communications
Authority (ACA)".
Information about currently available Ex versions (ATEX, FM, CSA etc.) can be supplied by your
E+H Sales Center on request. All information relevant to explosion protection is available in
separate Ex documents that you can order as necessary.
Promag W
No applicable approvals or certification
Promag P
No applicable approvals or certification
Promag H
• 3A authorization and EHEDG-tested
• Seals → in conformity with FDA (except Kalrez seals)
The flowmeter has successfully passed all the test procedures carried out and is certified and
registered by the PNO (PROFIBUS User Organization). The device thus meets all the requirements
of the following specifications:
• Certified in accordance with PROFIBUS Profile Version 3.0 (device certification number: available
on request)
• The measuring device can also be operated with certified devices of other manufacturers
(interoperability).
Measuring devices with a nominal diameter smaller than or equal to DN 25 correspond to Article
3(3) of the EC Directive 97/23/EC (Pressure Equipment Directive) and have been designed and
manufactured according to good engineering practice. For larger nominal diameters, optional
approvals according to Cat. II/III are available when required (depends on fluid and process
pressure).
• EN 60529
Degrees of protection by housing (IP code)
• EN 61010
Protection Measures for Electrical Equipment for Measurement, Control, Regulation and
Laboratory Procedures.
• EN 61326/A1 (IEC 1326)
"Emission in accordance with requirements for Class A".
Electromagnetic compatibility (EMC-requirements).
• NAMUR NE 21
Electromagnetic compatibility (EMC) of industrial process and laboratory control equipment.
• NAMUR NE 43
Standardization of the signal level for the breakdown information of digital transmitters with
analog output signal.
• NAMUR NE 53
Software of field devices and signal-processing devices with digital electronics.
Technical data
175
Advertisement
Table of Contents
