Certificates And Approvals; Registered Trademarks - Endress+Hauser PROFI BUS Proline Promag 53 PROFIBUS DP Operating Manual

Identification
14
2.2

Certificates and approvals

The devices are designed in accordance with good engineering practice to meet state-of-the-art
safety requirements, have been tested, and left the factory in a condition in which they are safe to
operate. The devices comply with the applicable standards and regulations in accordance with EN
61010 "Protection Measures for Electrical Equipment for Measurement, Control, Regulation and
Laboratory Procedures" and with the EMC requirements of EN 61326/A1.
The measuring system described in this Operating Manual is therefore in conformity with the
statutory requirements of the EC Directives. Endress+Hauser confirms successful testing of the
device by affixing to it the CE mark.
The measuring system complies with the EMC requirements of the "Australian Communications
Authority (ACA)".
The flowmeter has successfully passed all the test procedures carried out and is certified and
registered by the PNO (PROFIBUS User Organization).
The device thus meets all the requirements of the following specifications:
• Certified to PROFIBUS Specification Profile 3.0 version
(Device certification number: provided upon request)
• The measuring device can also be operated with certified devices of other manufacturers
(interoperability).
2.3

Registered trademarks

® ®
KALREZ and VITON
Registered trademarks of E.I. Du Pont de Nemours & Co., Wilmington, USA
®
TRI-CLAMP
Registered trademark of Ladish & Co., Inc., Kenosha, USA
®
PROFIBUS
Registered trademark of the PROFIBUS User Organization, Karlsruhe, D
®
HistoROM™, S-DAT , T-DAT™, F-CHIP
®
Applicator
Registered or registration-pending trademarks of Endress+Hauser Flowtec AG, Reinach, CH
Proline Promag 53 PROFIBUS DP/PA
® ®
, ToF Tool - Fieldtool Package, Fieldcheck
®
,
Endress+Hauser