10.1.12 Certificates And Approvals; 10.1.13 Ordering Information; 10.1.14 Accessories - Endress+Hauser Proline Prosonic Flow 93C Operating Instructions Manual

Proline Prosonic Flow 93C FOUNDATION Fieldbus
CE mark
C-Tick mark
Ex approval
Certification
FOUNDATION Fieldbus
Other standards and
guidelines
Endress+Hauser

10.1.12 Certificates and approvals

The measuring system is in conformity with the statutory requirements of the EC Directives.
Endress+Hauser confirms successful testing of the device by affixing to it the CE mark.
The measuring system complies with the EMC requirements of the "Australian Communications
and Media Authority (ACMA)".
Information on the currently available Ex-rated versions (ATEX, FM, CSA, etc.) can be supplied by
your Endress+Hauser Sales Center on request. All information relevant to explosion protection is
available in separate documents that you can order as necessary.
The flowmeter has passed all the test procedures implemented and has been certified and registered
by the Fieldbus Foundation. The device thus meets all the requirements of the following
specifications:
• Certified to FOUNDATION Fieldbus specification
• The flowmeter meets all the specifications of the FOUNDATION Fieldbus-H1.
• Interoperability Test Kit (ITK), revision 5.01:
The device can also be operated with certified devices of other manufacturers.
• Physical Layer Conformance Test by Fieldbus Foundation
• EN 60529
Degrees of protection provided by enclosures (IP code).
• EN 61010-1
Safety requirements for electrical equipment for measurement, control and laboratory use.
• IEC/EN 61326
"Emission in accordance with Class A requirements".
Electromagnetic compatibility (EMC requirements).
• ANSI/ISA-S82.01
Safety Standard for Electrical and Electronic Test, Measuring, Controlling and Related
Equipment - General Requirements. Pollution Degree 2, Installation Category II.
• CAN/CSA-C22.2 No. 1010.1-92
Safety Requirements for Electrical Equipment for Measurement and Control and Laboratory Use.
Pollution Degree 2, Installation Category II.
• NAMUR NE 21
Electromagnetic compatibility (EMC) of industrial process and laboratory control equipment.
• NAMUR NE 43
Standardization of the signal level for the breakdown information of digital transmitters with
analog output signal.
• NAMUR NE 53
Software of field devices and signal-processing devices with digital electronics.

10.1.13 Ordering information

The Endress+Hauser service organization can provide detailed ordering information and
information on the order codes on request.

10.1.14 Accessories

Various accessories, which can be ordered separately from Endress+Hauser, are available for the
transmitter and the sensor → ä 56.
Technical data
85