Endress+Hauser PROFI BUS Proline Promag 53 PROFIBUS DP Operating Manual page 2

Brief operating instructions
2
Brief operating instructions
These brief operating instructions show you how to configure your measuring device quickly and
easily:
First of all, familiarize yourself with the safety instructions so that you can carry out the following working steps quickly
and easily. Here you can find information about such topics as the designated use of the measuring device, operational
safety and the safety icons and symbols used in the document.
The "Installation" section contains all of the necessary information for incoming acceptance, the installation conditions
that have to be observed (orientation, installation site, vibrations etc.), through to the actual installation of the measuring
device, including information about seals, grounding and the required tightening torques for the compact and remote
versions.
The "Wiring" section describes the electrical connection of the measuring device and the connection of the remote
version connecting cable. Additional topics of this chapter include:
• The specifications of the coil/signal cable and the fieldbus cable
• The terminal assignment
• The potential matching and degree of protection
Display and operating elements
The available display and operating elements of the local display and working with the function matrix are presented
here.
The measuring device can be configured and operated using the local display and using configuration programs from
various manufacturers.
Basic configuration (device parameters, automation functions)
You can commission your measuring device quickly and easily, using the special "Quick Setup" menu. It enables you to
directly configure important basic functions using the local display, for example display language, measured variables,
units of measure, type of signal, etc.
The following adjustment is to be made separately as necessary:
– Empty/full-pipe adjustment for empty pipe detection → Page 129 ff.
Commissioning the PROFIBUS interface.
System integration and cyclic data transmission
Use of the device master files (GSD files) → Page 106 ff.
Cyclic data transmission → Page 110 ff.
Information about setting the hardware write protection, the device address, etc. for:
• PROFIBUS DP → Page 82 ff.
• PROFIBUS PA→ Page 87 ff.
Safety instructions
▼
Installation
▼
Wiring
▼
▼
Configuration programs
▼
▼
PROFIBUS interface
▼
▼
Hardware settings
▼
Proline Promag 53 PROFIBUS DP/PA
Page 9
Page 15
Page 49
Page 71
Page 79 ff.
Page 89 ff.
Page 101 ff.
Endress+Hauser