Starting And Exiting Measurement; Starting Measurement; Exiting Measurement - Fuji Electric ZSVS-2 Instruction Manual

3.3 Starting and exiting measurement

Perform measurement after zero/span calibration is completed.

3.3.1 Starting measurement

(1) Display measurement 1 screen or measurement 2 screen.
(2) Press the
from the sample gas inlet.
Caution on operation
• The key can be set to ON/OFF (measurement/
standby mode) only on measurement screens 1 to 2.
Be sure to check the displayed screen before setting the
key to ON/OFF.
• Measurement can also be made during warm-up opera-
tion, but zero/span calibration cannot be performed.
Note that insufficient warm-up operation may cause
reading fluctuation.

3.3.2 Exiting measurement

(1) Display measurement 1 screen or measurement 2 screen.
(2) Press the
is terminated.
key, and the pump is started to suck the gas
key, and the pump is stopped and measurement
- 20 -
INZ-TN2ZSVS-E