Fuji Electric ZSVS-2 Instruction Manual page 24

(2) Menu mode screen
The menu mode setting and select screen are shown below.
Measurement 1 or
measurement 2 screen
MODE
(1)
(4)
MODE
Measurement 1 screen
No.
(1) Status display
(2) Message display
ESC
(3) Setting/select item Select settings or select items to be
(4) Cursor
(2)
(3)
1. Zero/span calibration
2. Zero calibration time/span concentration value setting
3. Gas change time setting
4. Changeover of range
5. Error cancel
6. CP calculation value condition setting
Note: This mode is not displayed if the optional function is
7. Parameter setting
- 12 -
Name
Displays current status.
Displays guideline for operation.
changed or checked using the cursor.
Menu contents
1) Executes selection and calibration of zero/span gas.
• "Wet Air/Dry", "Wet N
2) Executes span calibration operation and span
calibration.
• "Each, Both"
1) Performs "zero calibration time setting."
2) Performs "span calibration concentration value
setting."
• Performs "gas change time setting."
• Performs "range setting" of measurement target.
• "Cancels" error display.
1) Performs "CO concentration value setting."
2) Performs "Furnace temperature setting."
not provided.
1) Performs "date/time setting."
2) Performs "key lock setting."
3) Performs "output hold setting."
4) Performs "average output value reset."
5) Performs "display OFF time setting."
6) Performs "password input for entering maintenance
mode."
Function
/Dry"
2
INZ-TN2ZSVS-E