Table of Contents
Advertisement
4.1.4 Switching ranges
The range and the display selected in this mode is output.
The correction value, the average correction value and CP calculation value are also calculated in
selection range.
Initial value
• "Minimum range"
1) Move the cursor to <4. Changeover of Range> using
the
key, and press the
The screen switches as shown at right.
2) Move the cursor to the component (Ch) to be set using
the
key, and press the
The cursor moves to the range currently selected.
3) Move the cursor to the range to be set using the
key, and then press the
The cursor at the selected range is highlighted as ,
and the previous screen appears again.
4) Make the setting for other components in the same
manner.
The setting has now been completed.
key.
key.
key.
- 32 -
ENT
ESC
,
ENT
ESC
,
ENT
,
Setting complete
INZ-TN2ZSVS-E
Advertisement
Table of Contents
