Table of Contents
Advertisement
4.3.1 Selecting output type
Instantaneous correction value or average correction value or CP calculation value can be selected in
this mode.
Caution on setting
• Setting can be made only when CO, and CO
measured components.
• Be sure to select "NONE" not to make the setting.
• See "1.4.2 Outline of display screen" for each operational expression.
Setting contents
Selection can be made from "Corrected concentration value," "Corrected average concentration
value," "CP calculation value" or "None."
Initial value
"Depends on specifications."
(1) Move the cursor to <1. CH No.> using the
and press the
The screen switches as shown at right.
(2) Move the cursor to the channel (CH) to be set using
the
key.
Press the
field.
Caution on setting
• Be sure to make the setting, following the proper
order.
• Do not select the same output type.
(3) Select setting contents using the
the
key.
The CH selection screen appears again.
(4) Make the setting of other channels in the same manner.
Setting has now been completed.
key.
key, and the cursor moves to the entry
key, and press
(CO calculation value) analyzers are added for
2
key,
- 46 -
ENT
ESC
,
ENT
ESC
,
ENT
,
Setting complete
INZ-TN2ZSVS-E
Advertisement
Table of Contents
