Names Of External Connectors And Descriptions - Fuji Electric ZSVS-2 Instruction Manual

1.3.2 Names of external connectors and descriptions

<Analog output connector>
Non-isolated linear connector for 4 to 20mA DC or
0 to 1V DC
Output of up to 8 channels is allowed.
Output is made for corresponding channel No. on a
one-to-one basis.
Permissible load: 4 to 20mA DC, 550Ω or lower
A female connector is supplied for the main unit
(DS-25S-T-N by Japan Aviation Electronics
Industry Co., Ltd.)
Use the supplied cable (1m) (DB-25P) for connection.
13
25
<Communication output connector>
Input/output signal connector for RS232-C com-
munication
Modbus protocol (Creation of communication
program is required. Refer to separately sold
transmission specifications.)
A male connector is supplied for the main unit.
Use commercially available cross cable (DE-9S)
for connection.
Note 1: NC indicates that the pin is not used.
Note 2: Different numbers are assigned for male (P) and female (S) pins. Make connections, paying
attention to the numbers.
0 to 1V DC, 100kΩ or higher
1
14
1 5
6 9
Pin No.
+
Between 1 and 2
Between 3 and 4
Between 5 and 6
Between 7 and 8
Between 9 and 10
Between 11 and 12
Between 13 and 14
Between 15 and 16
17 to 25
Pin No.
+
1
2
3
4
5
6
7
8
9
- 8 -
Description
-
Ch1 analog output
Ch2 analog output
Ch3 analog output
Ch4 analog output
Ch5 analog output
Ch6 analog output
Ch7 analog output
Ch8 analog output
NC
Description
-
NC
TXD
RXD
NC
GND
NC
NC
NC
NC
INZ-TN2ZSVS-E