Table of Contents
Advertisement
d) On rear panel of monitor, remove three screws fastening battery housing.
e) Carefully slide battery housing from rear case assembly.
Screws fastening
battery housing
f)
Disconnect speaker twisted-pair-connector from power supply PCB.
Speaker is mounted on one side of battery housing.
g) If printer had been installed, disconnect ribbon cable from printer PCB.
Printer PCB may be removed by removing four screws fastening PCB to
battery housing.
Section 6: Disassembly Guide
Procedure
Illustration
Procedure
Illustration
6-13
Advertisement
Table of Contents
Troubleshooting
