Serial Port Interface - Mallinckrodt NELLCOR NPB-4000 Service Manual

Section 13: Microprocessor Computer and Control –Theory of Operation
13.5.2 16-Bit Word Transmitted to the A/D Converter and Front End
13.5.3 A/D Converter Receiver Control
13.5.4 SpO INTERFACE
2
13.5.5 ISOLATED FRONT END POWER SIGNALS
13.6 RS-232 SERIAL PORT INTERFACE
13-8
The A/D converter is a pipelined converter and transmits the result of the
previous conversion when receiving the next transmission for a conversion. The
previous conversion is transmitted to the SSIO unit' s receiver and the SSIO then
requests a DMA transfer to memory.
The microprocessor' s asynchronous channel 2 (SIO2) is used to interface to the
SpO unit via opto-isolators. There are two signals, transmit and receive. This
2
is a UART-type unit and when the SpO
generates an interrupt to the software. When the software wants to transmit a
byte to the SpO , it transfers data to the SIO transmitter and the SIO unit
2
automatically transmits it to the SpO
The isolated Front End requires its own power supply and voltages, separate
from the other voltages in the system. The FPGA generates a 100 kHz signal
that connects to an isolation transformer. These signals are enabled/disabled by
a bit in the CS5 control register. These signals are also connected to, and in
synchronization with, the 50 kHz power supply clock. Resetting the Front End
can be accomplished by turning the 100 kHz clock off, then back on again. This
turns the Front End power supply off, then back on.
The RS-232 output serial port uses one of the asynchronous units of the
DUART. It is programmed by the software using CS4 and the A3 address bit set
to 0. This is done in the FPGA and output as DUARTCS0. The eight
programmable registers are internal to the UART channel and are set up for baud
rate, parity, number of bits to transmit, and start and stop bits. This channel also
has an internal register with an extra bit. The circuit uses this bit as the
NURSECALL signal on pin 9 of the RS-232 connector.
Figure: 13-5: 16 Bit Word
transmits, the SIO receives the data and
2
2.