Mallinckrodt NELLCOR NPB-4000 Service Manual page 55

Step A2
To remove carrying handle:
a) Use screwdriver to remove two fastening screws and washers. Retain for
reassembly.
b) Remove handle by sliding it straight back toward rear of monitor.
Step A3
To remove printer:
a) Press Paper Eject button on printer (right side). Door will drop forward.
b) Remove paper roll, if installed. Two fastening screws are visible at back
panel of printer.
c) Use screwdriver to back out captive fastening screws.
d) Pull printer straight out side of monitor, disengaging connector at rear of
module from Printer PCB in assembly.
Removal of Printer PCB can be accomplished only after front and rear cases
are separated.
Section 6: Disassembly Guide
Procedure
Illustration
Procedure
6-5