Figure 28: Connecting To The Ethernet Port On An Srx110 Services Gateway - Juniper SRX110 Manual

SRX110 Services Gateway Hardware
114

Figure 28: Connecting to the Ethernet Port on an SRX110 Services Gateway

To connect to the Ethernet port:
From the management device that you use to access the J-Web interface (such as a
1.
PC or a laptop), verify that the address of the port you connect to is set to one of the
following values:
Ethernet address on the
Ethernet address from a DHCP server
Plug one end of the CAT-5e (Ethernet cable) into the Ethernet port on the management
2.
device.
Connect the other end of the Ethernet cable to any of the built-in Ethernet ports
3.
through
fe-0/0/1 fe-0/0/7
Wait until the Status LED on the front panel of the services gateway turns solid green.
4.
Turn on the power to the management device. The services gateway assigns an IP
5.
address to the management device within the
management device is configured to use DHCP.
NOTE: After connecting the management device to the services gateway,
the DHCP server process on the services gateway assigns an IP address
automatically to the management device. Ensure that the management
device acquires an IP address on the
than 192.168.1.1
From the management device, open a Web browser and enter the IP address
6.
in the address field if the management device is configured using the DHCP.
Configure basic settings for your services gateway.
7.
subnetwork other than
192.168.1.0/24
on the services gateway.
192.168.1.0/24
192.168.1.0/24
) from the device.
192.168.1.1
subnetwork if the
subnetwork (other
192.168.1.1
Copyright © 2012, Juniper Networks, Inc.