Table 42: Port Settings For Connecting To The Cli At User End - Juniper SRX110 Manual

Related
Documentation
Copyright © 2012, Juniper Networks, Inc.
Select the port to which the modem is connected (for example,
3. COM
Configure the port settings shown in
4.

Table 42: Port Settings for Connecting to the CLI at User End

Port Setting
Bits per second
Data bits
Parity
Stop bits
Flow control
In the HyperTerminal window, enter
5.
For more information on the AT commands, see the following guides:
Junos OS Initial Configuration Guide for Security Devices
Junos OS Monitoring and Troubleshooting Guide for Security Devices
An OK response verifies that the modem can communicate successfully with the
port on the PC or laptop.
Dial the modem that is connected to the console port on the services gateway by
6.
entering
ATDT remote-modem-number
connected to the console port on the services gateway is
.
0013033033030
The services gateway login prompt appears.
Log in as the user root . No password is required at initial connection, but you must
7.
assign a root password before committing any configuration settings.
Connecting the Modem at the SRX110 Services Gateway End on page 117
Connecting the Modem to the Console Port on the SRX110 Services Gateway on page 118
SRX110 Services Gateway Software Configuration Overview on page 121
Chapter 16: Establishing Basic Connectivity
Table 42 on page 119.
Value
9600
8
None
1
None
.
AT
. For example, if the number of the modem
0013033033030
).
COM1
COM
, enter ATDT
119