Table 37: Srx110 Services Gateway Wall Installation Parts - Juniper SRX110 Manual

SRX110 Services Gateway Hardware
96
To install the device on a wall:
Place the device on a flat, level surface, with the Juniper Networks logo facing up. The
1.
logo is embossed on the top cover. Ensure that the rubber feet are attached to the
bottom of the chassis.
Position a mounting bracket on each side of the chassis as shown in
2.
page 96.
Figure 20: SRX110 Services Gateway Wall Installation — Attaching the
Mounting Brackets
Table 37 on page 96 lists the parts to use to install the SRX110 Services Gateway on
a wall. The numbers in
on page 96.

Table 37: SRX110 Services Gateway Wall Installation Parts

Number
1
2
Use a Phillips (+) screwdriver, number 1, to install the screws that secure the mounting
3.
brackets to the chassis.
If you are using wall anchors to support the chassis, install two pairs of anchors on
4.
the wall.
Have one person grasp the sides of the device, lift it, and position it on the wall.
5.
Have a second person install two pairs of mounting screws through the bracket holes
6.
on either side of the device to secure it to the wall.
Verify that the mounting screws on one side are aligned with the mounting screws on
7.
the opposite side and that the device is level
Figure 20 on page 96 correspond to the numbers in
Part
Mounting brackets
Screws (mounting bracket)
(Figure 21 on page
Figure 20 on
Table 37
97).
Copyright © 2012, Juniper Networks, Inc.