Configuring The Integrated Vdsl2 Interface On The Srx110 Services Gateway - Juniper SRX110 Manual

SRX110 Services Gateway Hardware

Configuring the Integrated VDSL2 Interface on the SRX110 Services Gateway

28
To use J-Web to perform basic configuration for the integrated VDSL2 interface and to
configure network interfaces for the services gateway:
In J-Web, select Configure>Interfaces.
1.
The Interfaces page appears and lists the network interfaces present on the services
gateway, along with configuration information (if configured).
To configure properties for a network interface, select the interface name (pt-1/0/0),
2.
and click Edit.
To use the VDSL2 port, you must assign it to a security zone other than the Null zone.
3.
Optionally, you can also assign the port an IP address (for example, 192.168.3.1/24).
Enter or select the following settings:
Select Configure>Security>Zones/Screens.
a.
Add or select a security zone other than Null; for example, Trust.
b.
For host inbound traffic, set the following:
c.
System Services=Allow All.
Protocols=Allow All.
Click OK to save changes, and click Commit to apply the configuration and other
d.
pending changes.
To use the VDSL2 port (VDSL/ADSL-POTS or VDSL/ADSL-ISDN), you must also set
4.
security policies. Select the following settings:
Select Configure>Security>Apply Policy.
a.
Set Policy Action: Default Policy Action=Permit-All.
b.
Click OK to save changes, and click Commit to apply the configuration and other
c.
pending changes (if any).
For more information, in the J-Web user interface, select Configure>Interfaces, and click
Help.
To use the CLI to perform basic configuration of the integrated VDSL2 interface and to
configure network interfaces for the services gateway:
Verify that the VDSL2 interface is installed on the device:
show chassis hardware
Verify the status of the interface:
show interfaces terse
Assign the port an IP address:
Copyright © 2012, Juniper Networks, Inc.