Juniper SRX110 Manual page 124

SRX110 Services Gateway Hardware
Related
Documentation
106
CAUTION: Use the graceful shutdown method to halt, power off, or reboot
the services gateway. Use the forced shutdown method as a last resort to
recover the services gateway if the services gateway operating system is not
responding to the graceful shutdown method.
CAUTION: Forced shutdown can result in data loss and corruption of the file
system.
NOTE: To remove power completely from the device, unplug the AC power
cord or switch off the power source.
After powering off a power supply, wait at least 10 seconds before turning it
back on. After powering on a power supply, wait at least 10 seconds before
turning it off.
The Power button on the services gateway is a standby power switch.
If you press the Power button to power off the device when it is still connected
to a power source, 12-V power will still be available in the chassis and the
device will be fully powered off.
NOTE: When you are powering off the device, the system displays the
following message:
the power cable to completely disconnect the power from the device.
NOTE: You can use the
of the services gateway.
For more information about halting, powering off, or rebooting the services gateway using
the command-line interface (CLI), see the following guides:
Junos OS Initial Configuration Guide for Security Devices
Junos OS Monitoring and Troubleshooting Guide for Security Devices
Powering On the SRX110 Services Gateway on page 105
Resetting the SRX110 Services Gateway on page 107
Connecting the SRX110 Services Gateway to the Power Supply on page 101
Grounding the SRX110 Services Gateway on page 103
Using the Reset Config Button on the SRX110 Services Gateway on page 145
Turning the system power off
command to schedule a reboot
request system reboot
Copyright © 2012, Juniper Networks, Inc.
. You can now safely remove