Grounding The Srx110 Services Gateway; Figure 27: Grounding The Srx110 Services Gateway - Juniper SRX110 Manual

Related
Documentation

Grounding the SRX110 Services Gateway

Copyright © 2012, Juniper Networks, Inc.
Chapter 14: Connecting, Grounding, and Powering On the SRX110 Services Gateway
transmit data. You must configure each network interface before it can operate on the
device.
To connect and organize an interface cable for the device:
Have ready a length of the type of cable used by the interface.
1.
Insert the cable connector into the cable connector port on the interface faceplate.
2.
Arrange network cables as follows to prevent them from dislodging or developing
3.
stress points:
Secure cables so that they are not supporting their own weight as they hang to the
floor.
Place excess cable out of the way in neatly coiled loops.
Use fasteners to maintain the shape of cable loops.
Connecting the SRX110 Services Gateway to the Power Supply on page 101
Grounding the SRX110 Services Gateway on page 103
Interface Cable and Wire Specifications for the SRX110 Services Gateway on page 71
General Site Guidelines for Installing the SRX110 Services Gateway on page 38
To meet safety and electromagnetic interference (EMI) requirements and to ensure
proper operation, you must adequately ground the SRX110 Services Gateway before
connecting power.
Figure 27 on page 103 illustrates connecting a grounding cable to the services gateway.

Figure 27: Grounding the SRX110 Services Gateway

To ground the device, connect a grounding cable to earth ground and then attach it to
the chassis grounding points, using one M3 screw.
103