Connecting The Srx110 Services Gateway To The J-Web Interface; Figure 27: Connecting To The Ethernet Port On An Srx110 Services Gateway - Juniper SRX110 H2 Hardware Manual

SRX110 Services Gateway Hardware Guide for H2 Model Numbers

Connecting the SRX110 Services Gateway to the J-Web Interface

86
If you plan to use the J-Web interface to configure the SRX110 Services Gateway, you
must connect through one of the built-in Ethernet management ports.
When the services gateway is powered on for the first time, the system looks for a Dynamic
Host Configuration Protocol (DHCP) server. If it does not find one, the system assigns
an IP address within the 192.168.1.0/24
system.
To connect to the J-Web interface through any of the ports
on the services gateway, see

Figure 27: Connecting to the Ethernet Port on an SRX110 Services Gateway

To connect to the Ethernet port:
From the management device that you use to access the J-Web interface (such as a
1.
PC or a laptop), verify that the address of the port you connect to is set to one of the
following values:
Ethernet address on the
Ethernet address from a DHCP server
Plug one end of the CAT-5e (Ethernet cable) into the Ethernet port on the management
2.
device.
Connect the other end of the Ethernet cable to any of the built-in Ethernet ports
3.
through
fe-0/0/1 fe-0/0/7
Wait until the Status LED on the front panel of the services gateway turns solid green.
4.
subnetwork to any devices connected to the
Figure 27 on page 86.
subnetwork other than
192.168.1.0/24
on the services gateway.
Copyright © 2015, Juniper Networks, Inc.
through
fe-0/0/1 fe-0/0/7
192.168.1.1