Installing The Mounting Hardware; Preparing The Srx110 Services Gateway For Rack-Mount Installation; Table 33: Srx110 Services Gateway Preinstallation Checklist For Rack-Mount - Juniper SRX110 Manual

CHAPTER 12

Installing the Mounting Hardware

Preparing the SRX110 Services Gateway for Rack-Mount Installation

Copyright © 2012, Juniper Networks, Inc.
Preparing the SRX110 Services Gateway for Rack-Mount Installation on page 85
Preparing the SRX110 Services Gateway for Desk-Mount Installation on page 86
Preparing the SRX110 Services Gateway for Wall-Mount Installation on page 87
You can mount an SRX110 Services Gateway on 4-post (telco) racks, enclosed cabinets,
and open-frame racks.
NOTE: The SRX110 Services Gateway cannot be center-mounted in a rack.
Table 33 on page 85 lists the tasks you need to perform before installing the device.
Table 33: SRX110 Services Gateway Preinstallation Checklist for
Rack-Mount Installation
Task
Verify that the site meets the requirements.
Verify that the racks or cabinets meet the specific
requirements.
Place the rack or cabinet in its permanent location,
allowing adequate clearance for airflow and
maintenance, and secure it to the building structure.
Remove the services gateway chassis from the
shipping carton.
Additional Information
"Site Preparation Checklist for the SRX110
Services Gateway" on page 35
"SRX110 Services Gateway Rack
Requirements" on page 39
"Clearance Requirements for Airflow and
Hardware Maintenance of the SRX110
Services Gateway" on page 40
"Unpacking the SRX110 Services Gateway"
on page 81
85