Srx110 Services Gateway General Safety Guidelines And Warnings - Juniper SRX110 Manual

Related
Documentation

SRX110 Services Gateway General Safety Guidelines and Warnings

Copyright © 2012, Juniper Networks, Inc.
¡Atención! Este símbolo de aviso significa peligro. Existe riesgo para su
integridad física. Antes de manipular cualquier equipo, considerar los riesgos
que entraña la corriente eléctrica y familiarizarse con los procedimientos
estándar de prevención de accidentes.
Varning! Denna varningssymbol signalerar fara. Du befinner dig i en situation
som kan leda till personskada. Innan du utför arbete på någon utrustning
måste du vara medveten om farorna med elkretsar och känna till vanligt
förfarande för att förebygga skador.
SRX110 Services Gateway General Safety Guidelines and Warnings on page 45
SRX110 Services Gateway Fire Safety Requirements on page 49
SRX110 Services Gateway Installation Safety Guidelines and Warnings on page 50
SRX110 Services Gateway Laser and LED Safety Guidelines and Warnings on page 54
SRX110 Services Gateway Electrical Safety Guidelines and Warnings on page 62
SRX110 Services Gateway Maintenance and Operational Safety Guidelines and Warnings
on page 57
General Safety Guidelines and Warnings
The following guidelines help ensure your safety and protect the services gateway from
damage. The list of guidelines might not address all potentially hazardous situations in
your working environment, so be alert and exercise good judgment at all times.
Perform only the procedures explicitly described in these topics. Ensure that only
authorized service personnel perform other system services.
Keep the area around the chassis clear and free from dust before, during, and after
installation.
Keep tools away from areas where people could trip on them.
Wear safety glasses if you are working under any conditions that could be hazardous
to your eyes.
Do not perform any actions that create a potential hazard to people or make the
equipment unsafe.
Never install or manipulate wiring during electrical storms.
Never install electrical jacks in wet locations unless the jacks are specifically designed
for wet environments.
Do not open or remove chassis covers or sheet metal parts unless instructions are
provided in this guide. Such an action could cause severe electrical shock.
Chapter 7: Safety and Regulatory Compliance Information
45