Gateway; Connecting The Srx110 Services Gateway To The Power Supply - Juniper SRX110 Manual
Services gateway hardware
Hide thumbs
Also See for SRX110:
- Hardware manual (168 pages) ,
- Quick start manual (6 pages) ,
- Quick start manual (6 pages)
Table of Contents
Advertisement
CHAPTER 14
Connecting, Grounding, and Powering On
the SRX110 Services Gateway
Connecting the SRX110 Services Gateway to the Power Supply
Copyright © 2012, Juniper Networks, Inc.
Connecting the SRX110 Services Gateway to the Power Supply on page 101
Connecting and Organizing the SRX110 Services Gateway Interface Cables on page 102
Grounding the SRX110 Services Gateway on page 103
Powering On the SRX110 Services Gateway on page 105
Powering Off the SRX110 Services Gateway on page 105
Resetting the SRX110 Services Gateway on page 107
To connect the device to the power supply:
CAUTION:
Before connecting the device to the power supply, attach an ESD
strap to an ESD point and place the other end of the strap around your bare
wrist.
NOTE:
If you are installing your services gateway on a desk, ensure that your
device is adequately grounded using the grounding point on the back panel
of the chassis.
Plug the DC connector end of the power cable into the power connector on the back
1.
of the device (see
Figure 26 on page
Plug the AC adapter end of the power cable into an AC power outlet.
2.
102).
101
Advertisement
Table of Contents
