Appendix E Cable Connector Pinouts; Connector Pinouts For The Srx5400 Services Gateway Routing Engine Ethernet Port - Juniper SRX5400 Hardware Manual

APPENDIX E
Cable Connector Pinouts
RJ-45 Connector Pinouts for the SRX5400 Services Gateway Routing Engine Ethernet
Port
Related
Documentation
Copyright © 2014, Juniper Networks, Inc.
RJ-45 Connector Pinouts for the SRX5400 Services Gateway Routing Engine Ethernet
Port on page 209
RJ-45 Connector Pinouts for the SRX5400 Services Gateway Routing Engine Auxiliary
and Console Ports on page 210
The port on the Routing Engine labeled
Ethernet RJ-45 receptacle that accepts an Ethernet cable for connecting the Routing
Engine to a management LAN (or other device that supports out-of-band management).
Table 39 on page 209 describes the RJ-45 connector pinout.
Table 39: RJ-45 Connector Pinout for the Routing Engine ETHERNET Port
Pin Signal
1 TX+
2 TX-
3 RX+
4 Termination network
5 Termination network
6 RX-
7 Termination network
8 Termination network
Routing Engine Interface Cable and Wire Specifications for the SRX5400 Services
Gateway on page 207
Connecting the SRX5400 Services Gateway to a Network for Out-of-Band Management
on page 58
is an autosensing 10/100-Mbps
ETHERNET
209