Table 8: Srx110 Services Gateway Built-In Hardware Interfaces - Juniper SRX110 Manual

SRX110 Services Gateway Hardware
12

Table 8: SRX110 Services Gateway Built-In Hardware Interfaces

Interface
Fast Ethernet
Universal Serial Bus (USB)
Console
Specification
The Fast Ethernet ports:
Consist of eight fixed ports
Are labeled as port 0/0 to
port 0/7 on the front panel
Provide link speeds of
10/100 Mbps
Operate in full-duplex and
half-duplex modes
Support flow control
Support autonegotiation
Support autosensing
The USB port:
Consists of one port
Supports the following
modes:
Full-speed
High-speed
Complies with USB revision
2.0
The console port:
Consists of one port
Uses an RJ-45 serial cable
connector
Supports the RS-232
(EIA-232) standard
Copyright © 2012, Juniper Networks, Inc.
Description
The Fast Ethernet ports can be
used:
To provide LAN connectivity
to hubs, switches, local
servers, and workstations.
To forward incoming data
packets to the device.
To receive outgoing data
packets from the device.
The USB port can be used:
To support a USB storage
device that functions as a
secondary boot device in
case of internal flash
memory device failure on
startup (if the USB storage
device is installed and
configured).
NOTE: You must install and
configure the USB storage
device on the USB port to use
it as a secondary boot device.
Additionally, the USB device
must have Junos OS installed.
To provide the USB
interfaces that are used to
communicate with many
types of USB storage
devices supported by Juniper
Networks.
The console port can be used:
To provide the console
interface.
To function as a
management port for
logging in to a device
directly.
To configure the device
using the CLI.