Establishing Basic Connectivity; Connecting The Srx110 Services Gateway To The J-Web Interface - Juniper SRX110 Manual
Services gateway hardware
Hide thumbs
Also See for SRX110:
- Hardware manual (168 pages) ,
- Quick start manual (6 pages) ,
- Quick start manual (6 pages)
Table of Contents
Advertisement
CHAPTER 16
Establishing Basic Connectivity
Connecting the SRX110 Services Gateway to the J-Web Interface
Copyright © 2012, Juniper Networks, Inc.
Connecting the SRX110 Services Gateway to the J-Web Interface on page 113
Connecting the Services Gateway to the CLI Locally on page 115
Connecting the Modem at the SRX110 Services Gateway End on page 117
Connecting the Modem to the Console Port on the SRX110 Services Gateway on page 118
Connecting to the CLI at the User End for the SRX110 Services Gateway on page 118
If you plan to use the J-Web interface to configure the SRX110 Services Gateway, you
must connect through one of the built-in Ethernet management ports.
When the services gateway is powered on for the first time, the system looks for a Dynamic
Host Configuration Protocol (DHCP) server. If it does not find one, the system assigns
an IP address within the
192.168.1.0/24
system.
To connect to the J-Web interface through any of the ports
on the services gateway, see
subnetwork to any devices connected to the
Figure 28 on page
114.
through
fe-0/0/1
fe-0/0/7
113
Advertisement
Table of Contents
