Monitoring The Srx110 Services Gateway Using Chassis Alarm Conditions - Juniper SRX110 Manual

SRX110 Services Gateway Hardware
Related
Documentation

Monitoring the SRX110 Services Gateway Using Chassis Alarm Conditions

142
Table 47: Component LEDs on the Services Gateway (continued)
LED State
Power LED Green
Amber
Off
Monitoring the SRX110 Services Gateway Using Chassis Alarm Conditions on page 142
Monitoring the SRX110 Services Gateway Chassis Using the CLI on page 139
Monitoring the SRX110 Services Gateway Power System on page 144
Maintaining the SRX110 Services Gateway Hardware Components on page 135
When the services gateway detects an alarm condition, the alarm LED on the front panel
turns red or amber as appropriate.
To view a more detailed description of the cause of the alarm , issue the
CLI command.
alarms
For more information on the
Junos OS Initial Configuration Guide for Security Devices
Junos OS Monitoring and Troubleshooting Guide for Security Devices
Table 48 on page 143 describes alarms that can occur for an SRX110 Services Gateway
chassis component.
Meaning
The device is receiving power
and is functioning normally.
The Power button has been
pressed and quickly released.
The device is not receiving
power.
command, see the following guides:
show chassis alarms
Possible Causes and
Corrective Actions
Normal condition. No action
is required.
Normal condition. No action
is required.
Normal condition if the
services gateway is
switched off. No action is
required.
If you have not powered off
the services gateway, verify
that the AC power cord
from the power source to
the device is not damaged,
the socket is in working
condition, and the device
has an AC input voltage
between 110 and 240 VAC.
See "Monitoring the SRX110
Services Gateway Power
System" on page 144.
show chassis
Copyright © 2012, Juniper Networks, Inc.