Srx110 Services Gateway Built-In Interfaces - Juniper SRX110 Manual

Related
Documentation

SRX110 Services Gateway Built-In Interfaces

Copyright © 2012, Juniper Networks, Inc.
Table 7: SRX110 Services Gateway Back Panel Components (continued)
Number Component
3 Lock
4 Grounding point
5 CompactFlash card
6 Power supply unit
7 Cable tie holder
NOTE:
If there is any problem with the CompactFlash card, you must return the
services gateway for repair or replacement. For this, you need to contact
Juniper Networks Technical Assistance Center (JTAC).
The cable tie holder provides support for holding the power cord to the
power supply point.
The lock allows you to lock and secure the device to the installation site.
SRX110 Services Gateway Specifications on page 7
SRX110 Services Gateway Built-In Interfaces on page 11
SRX110 Services Gateway LEDs on page 13
SRX110 Services Gateway Power Supply on page 17
Table 8 on page 12 summarizes the interface ports supported on the SRX110 Services
Gateway.
Chapter 2: Hardware Components and Specifications
11