Juniper SRX110 Manual page 161

Related
Documentation
Copyright © 2012, Juniper Networks, Inc.
Table 48: SRX110 Services Gateway Chassis Alarm Conditions and
Corrective Actions
Component Alarm Condition
Boot media The services gateway
boots from an alternate
boot device.
Hardware The services gateway
components chassis temperature or
on the chassis is too warm.
services
gateway
The services gateway
temperature is too high,
either because of an
internal overheating
condition or because
the maximum
recommended room
temperature has been
exceeded.
Monitoring the SRX110 Services Gateway Chassis Using the CLI on page 139
Monitoring the SRX110 Services Gateway Power System on page 144
Using the Reset Config Button on the SRX110 Services Gateway on page 145
Changing the Reset Config Button Behavior on the SRX110 Services Gateway on page 146
Juniper Networks Technical Assistance Center on page 147
Chapter 20: Monitoring Hardware Components
Action
If the internal flash memory fails at
startup, the services gateway
automatically boots from the alternative
boot device (USB storage device).
NOTE: If you configured your services
gateway to boot from an alternative boot
device, ignore this alarm condition.
Reformat the internal flash memory, and
install a bootable image. (See the
OS Initial Configuration Guide for
Security Devices and the Junos OS
Monitoring and Troubleshooting Guide
for Security Devices
.)
If you did not configure the services
gateway to boot from an alternative
boot device, contact Juniper Networks
Technical Assistance Center (JTAC). See
"Juniper Networks Technical Assistance
Center" on page 147.
Check the room temperature. See
"SRX110 Services Gateway
Specifications" on page 7.
Check the airflow. See "General Site
Guidelines for Installing the SRX110
Services Gateway" on page
The services gateway shuts down
automatically in 4 minutes.
Alarm
Severity
Amber
(minor)
Junos
Amber
(minor)
38.
Red
(major)
143