Performing Initial Software Configuration On The Srx220 Services Gateway Using The J-Web Interface Setup Wizard; Establishing Basic Connectivity - Juniper SRX220 Hardware Manual

SRX220 Services Gateway Hardware Guide for H Model Numbers
Related
Documentation
Performing Initial Software Configuration on the SRX220 Services Gateway Using the
J-Web Interface Setup Wizard

Establishing Basic Connectivity

94
family inet {
address 192.168.1.1/24;
}
}
}
lo0 {
unit 0 {
family inet {
address 172.16.1.24/32;
}
}
}
}
Optionally, configure additional properties by adding the necessary configuration
18.
statements. Then commit the changes to activate them on the services gateway.
[edit]
admin@device# commit
When you have finished configuring the services gateway, exit configuration mode.
19.
[edit]
admin@device# exit
admin@device>
Connecting an SRX220 Services Gateway to the CLI Locally on page 83
Connecting an SRX220 Services Gateway to the CLI Remotely on page 85
SRX220 Services Gateway Software Configuration Overview on page 77
SRX220 Services Gateway Secure Web Access Overview on page 82
This topic includes the following sections:
Establishing Basic Connectivity on page 94
Configuring Basic System Properties on page 96
To establish basic connectivity:
Connect an Ethernet cable from any of the ports labeled
1.
ge-0/0/1 through ge-0/0/7) on the services gateway to the Ethernet port on the
management device (workstation or laptop).
Connect the power cable to the device and a power source. (We recommend using
2.
a surge protector.) Note the following indications:
Power LED (green): The device is receiving power.
Status LED (green): The device is operating normally.
0/1 through 0/7 (interfaces
Copyright © 2016, Juniper Networks, Inc.