Establishing Basic Connectivity For The Srx100 Services Gateway; Srx100 Services Gateway Basic Connectivity - Juniper SRX100 Hardware Manual

Chapter 12
Establishing Basic Connectivity for the
SRX100 Services Gateway

SRX100 Services Gateway Basic Connectivity

SRX100 Services Gateway Basic Connectivity Overview
This chapter includes the following sections:
SRX100 Services Gateway Basic Connectivity on page 55
Connecting to an SRX100 Services Gateway on page 60
Configuring Basic Connectivity Settings on the SRX100 Services
Gateway on page 67
This topic includes the following sections on connecting the SRX100 Services Gateway
to the network and establishing basic connectivity:
SRX100 Services Gateway Basic Connectivity Overview on page 55
SRX100 Services Gateway Basic Connectivity Settings on page 56
Built-In Ethernet Ports for the SRX100 Services Gateway on page 58
Management Access for the SRX100 Services Gateway on page 59
The JUNOS Software is preinstalled on the services gateway. When the device is
powered on, it is ready to be configured.
If you are setting up a services gateway for the first time, you can use either J-Web
configuration editor or CLI configuration editor to configure basic connectivity.
If you are setting up many services gateways, autoinstallation can help automate the
configuration process.
Before you configure the services gateway for the first time, you should complete
the prerequisite tasks shown in Table 19 on page 56:
SRX100 Services Gateway Basic Connectivity
55