Enrolling Keyfob Transmitters; Deleting Keyfob Transmitters - Visonic PowerMaxExpress User Manual

Enter partition No.
(e.g. for partition 1&3
enter 13)
I OK
I OK
Continue the same way up to Code 8 and press
to return to SET USER CODES menu.
You may now select any other item on the USER
SETTINGS menu or quit programming by clicking
. When <OK> TO EXIT is displayed - click
I OK
.

Enrolling Keyfob Transmitters

Eight system users carry keyfob transmitters to
exercise better, quicker and safer system functions
control. Your control panel must recognize the
unique identification code (ID) of each such keyfob to
respond to commands transmitted by them.
Before anything else, gather up all keyfob units you
intend to enroll, and make sure they all have
batteries installed. Keyfob transmitter enrolling
involves the following steps:
A. Having entered your Master User Code successfully
(see above - Entering the User Settings Menu),
Click the
necessary) until the display will read:
ENROLL KEYFOB
OK
I
B. Click . The display will read:
KEYFOB No:
C. Suppose that the Keyfob you are about to enroll
is to be designated as Keyfob No. 5. Assuming
that memory location No. 5 is free - no keyfob has
yet been enrolled to it - click the <5> key. The
display will change to:
KEYFOB No:
The clear space at the far right tells you that the
memory location is free.
I OK
D. Click . The display will prompt you to
initiate a transmission from the chosen keyfob:
TRANSMIT NOW
E. Initiate a transmission from the chosen keyfob by
pressing any one of its pushbuttons. In response,
the "Happy Tune" (- - - –––) will sound. For
disabled partitioning mode, the display will be:
KEYFOB No:
Proceed to step "I" below.
D-303974 PowerMaxExpress User's Guide
U02: 1 2 3
button (repeatedly,
_
5
5
When partition is enabled, the display will read:
ACCESS TO PART
I OK
F. Click
F01: P1
G. Select the desired partitions via pushbuttons 1, 2
and 3 on the control panel keypad.
I OK
H. Click
KEYFOB No:
A dark box will appear at the far right, indicating
that the chosen Keyfob has been enrolled as
Keyfob No. 5.
I. From this point on, you may continue in several
different directions:

If you wish to enroll another keyfob, select
the desired number by:
- Clicking
- Clicking
- Clicking

To return to the main menu, click
This will bring back the display:
<OK> TO EXIT
You may now review and select any other mode on
the User menu (by clicking
if

Deleting Keyfob Transmitters

Occupied keyfob memory locations must be cleared
(enrolled ID must be deleted) before enrolling a new
ID. To delete an existing ID, proceed as follows:
A. Select the desired memory location, as described in
the previous paragraph, steps A-C. If, for example,
you selected keyfob No. 5, the display will read:
Keyfob No.
I OK
B. Click
<OFF> to delete
C. Click
Keyfob No.
Note that the dark box at the far right has
disappeared. It is now possible to enroll a new ID. It
is also possible to leave the cleared keyfob location
free and simply exit to the main menu.
USER SETTINGS
. The display will read
P2 P3
. The display will read:
5
to go up (678.....)
to go down (432.....)
 <keyfob #>.
or
5
. The display will change to:
. The display will change to:
5
.
).
21